System Status Icons; Status Icon Area - Linear 2GIG Go!Control GC2 User Manual

SYSTEM STATUS ICONS

The top part of the Control Panel's display is
the status area that shows the following:
• Current system mode
• Sensor status
• Current trouble alerts
Special icons are used to visually
TIP:
show your system's current
condition.

Status Icon Area

AC Power Icon
The AC power icon displays whether the
Control Panel is receiving AC line power or
not.
Phone Line Failure Icon
If the system detects a telephone line failure,
the Phone Line Failure Icon is displayed.
Backup Battery Status Icon
If the Control Panel's backup battery tests
low or exhausted, the Backup Battery Status
Icon is displayed.
Test Mode Icon
When the system is placed in System Test
Mode, the test mode icon will flash in the
status bar of the display during the testing.
Remote Access Icon
When the system is being remotely accessed
by using an optional TS1 Wireless Keypad,
the Remote Access Icon is displayed.
Radio Modem Icon
If the system's optional Cell radio modem is
installed, the cell radio icon is displayed on
the status bar while the cell radio is being
used to update software or add features.
House Icon
If an interior sensor is open (or a motion
detector has just been activated) the status
bar displays the House icon or Interior
Sensor Open Icon.
NOTE: During arming, the House Icon
flashes as a warning.
©2013 2GIG Technologies Inc. All Rights Reserved.
System Trouble Alerts
23