Airmotiv Flex Subwoofer Controls - Emotiva airmotiv SE8 User Manual

Airmotiv Flex Subwoofer Controls

Both the Airmotiv SE8 and Airmotiv SE12 Flex Subwoofers have identical controls and input
connections located on their rear panels.
1. High-Pass Crossover Frequency
This switch selects the crossover frequency for the high-pass filter portion of the internal bass
management on the Flex Sub. This switch controls ONLY the crossover frequency for the high-pass
filter that is applied to the Line Level Outputs on the Flex Sub.
2. Line Level Outputs
Connect the Line Level Outputs to the input on your power amp if the Flex Sub is providing bass
management for your system. These outputs provide an audio signal that has been processed by
the user configurable high-pass filter portion of the internal bass management on the Flex Sub.
3. Stereo Line Level Inputs
Use the Stereo Line Level Inputs to connect the Flex Sub to a line level source that has stereo full
range outputs. Also use this Input to connect the Flex Sub to the Subwoofer Output from a device
like the Emotiva PT-100, which provides a summed mono output for a subwoofer, but doesn't
include internal bass management capabilities. Since the Line Level Inputs are summed, if your
device has a single output, you may connect it to either of these inputs.
AIRMOTIV F
1 2
OUT
L
60 HZ
80 HZ
100 HZ
R
6
VOLUME
8
0 180
PHASE
110
10
S
lex ubwOOFeR
3 4 5
HIGH LEVEL IN
IN
L
-
+
LFE
R
STATUS
X-OVER
AUTO ON
POWER
11 12 13
Page 9
7
9