Table of Contents
Advertisement
AIRMOTIV F
S
lex
ubwOOFeR
9. Power Mode Switch (and Status LED)
Note: Your Flex Sub will only operate if the AC POWER Switch is turned ON. If the AC POWER
Switch is OFF, your Flex Sub will NOT operate.
When the Power Mode Switch is set to On, the Flex Sub will remain On continuously.
When the Power Mode Switch is set to Auto, the Flex Sub will turn On automatically when
incoming audio is detected. Once the Flex Sub is On, it will remain On for several minutes; if no
audio is detected after several minutes, the Flex Sub will return to Standby Mode.
The Status LED is located between the Volume Control and X-Over Control and shows the current
status of the Flex Sub. The Status LED illuminates Red when the Flex Sub is in Standby, and is
waiting for an audio signal, and Green when it is fully On. (The Status LED will always remain
Green when the Power Mode Switch is set to On and the AC Power Switch is set to On.)
10. Line Voltage Selector
This switch is used to select the appropriate line voltage for your area.
Note: Be sure to set this switch to the correct line voltage for your area. Failure to do so may
result in damage to your Flex Sub.
11. AC Power Switch
Use this switch to turn the main AC Power to your Flex Sub On and Off.
Note: Your Flex Sub will only operate if the AC POWER Switch is turned ON. If the AC POWER
Switch is OFF, your Flex Sub will NOT operate, and the Power Mode Switch will have no effect.
12. Fuse Holder
To change the fuse in your Flex Sub, remove the power cable, then gently pry the fuse
compartment open. (The fuse holder opens like a drawer.) Replace the fuse with one of the
correct value, replace the fuse drawer, and reinsert the power cable.
Note: If the fuse in your Flex Sub blows repeatedly without apparent reason, then you might
have an electrical fault in your Flex Sub, and you should call Emotiva Technical Support for
assistance.
13. IEC Power Cable Receptacle
The IEC Power Cable receptacle accepts any standard IEC power cable. A high quality commercial
power cable is provided with your Flex Sub.
Page 11
Advertisement
Table of Contents
