Displayport Ver; Input Port Ver; Auto Source Switch; Key Repeat Time - Samsung Odyssey G9 Series User Manual

DisplayPort Ver.

Select your Displayport.
― Incorrect settings may cause the screen to go blank. If this occurs, check the device specifications.
― If the product (when set to DisplayPort) is displaying the message
settings of the source device. press the JOG button to display the Function Key Guide screen and then select
→ System → DisplayPort Ver. → 1.1, 1.2 or 1.4.
― If setting the
DisplayPort Ver. to 1.1, for the bandwidth limitation of the DisplayPort 1.1 protocol, the actual
maximum output refreshing rate of the graphics cards cannot achieve the level of 120 Hz/144 Hz (C27G7*T* /
C32G7*T*), 120 Hz (C49G9*T*).
― If the PC has entered BIOS mode and the BIOS screen does not appear, go to the following path and then
select the mode. → System → DisplayPort Ver.
― The DisplayPort Ver. option is disabled if
Adaptive-Sync
― C49G9*T* model only.

Input Port Ver.

Select an HDMI version.
― The supportable device and resolution may differ depending on its version.
― When the version is changed, the screen may blink.
― If you set the
HDMI Mode to 1.4, some high resolutions may not be supported because of bandwidth
limitation of the HDMI 1.4 protocol.
― When the setting is not appropriate, a blank screen may appear. In this case, check the specifications of the
device.
― Set
HDMI Mode to 1.4 if the monitor is connected to an HDMI device and the monitor does not display the
screen properly, displays a blank screen, or does not play sound at all.
Check the cable connection and the
→ 1.1 or 1.2.
is set to On and there is a signal input.

Auto Source Switch

By activating, a new connected source is displayed automatically.
― This function may not be supported depending on the model or geographical area.

Key Repeat Time

Control the response rate of a button when the button is pressed.
Acceleration, 1 sec, or 2 sec can be selected. If
when a button is pressed.

Power LED On

Configure the settings to enable or disable the power LED located at the lower part of the product.
• Working: The power LED is on when the product is turned on.
• Stand-by: The power LED is on when the product is turned off.
No Repeat is selected, a command responds only once
35