Displayport Ver; Hdmi Mode - Samsung S32R750QEN User Manual

3
Base on the test result, select Yes / No
Do you still see the same problem on the test screen?
If you need to see the photo again, click Show Again.
Yes No
• You will see the following screen when you select Yes.
Self Diagnosis Complete
Contact the Samsung Call Center for assistance.
Please have the following information ready:
‐ Model Code: **************
‐ Software Version: *-*********-****.*
‐ S/N: **************
OK
• You will see the following screen when you select No.
Self Diagnosis Complete
If the test screen is okay during Self Diagnosis, your monitor may not have a problem. If the
problem persists, follow the steps below:
‐ Turn off your monitor and any other connected device, such as a PC. Turn on your monitor first
and then the other connected device.
‐ Update the operating system and graphics card driver to the latest version and restart your PC.
‐ Connect the other device, such as a PC, to a different input port on your monitor.
‐ Reset your monitor by pressing the jog button on the monitor and selecting System > Reset All.
‐ Replace the cable with the one enclosed with your monitor.
OK
/ Show Again.
Show Again

DisplayPort Ver.

Select the DisplayPort version to use.
― Incorrect settings may cause the screen to go blank. If this occurs, check the device specifications.
― If the product (when set to DisplayPort) is displaying the message
settings of the source device. press the JOG button to display the Function Key Guide screen and then
select → System → DisplayPort Ver. →

HDMI Mode

Select the HDMI mode to use.
― The supportable device and resolution may differ depending on its version.
― When the version is changed, the screen may blink.
― If you set the
HDMI Mode to 1.4, some high resolutions may not be supported because of bandwidth
limitation of the HDMI 1.4 protocol.
― When the setting is not appropriate, a blank screen may appear. In this case, check the specifications of the
device.
― This menu is not available when
PIP/PBP Mode
Check the cable connection and the
1.1 or 1.2↑.
is set to On and the Screen Size is set to (PBP Mode).
35