modway EEI-2126 Manual

Office chair

EEI –2126/2127

Thank you for purchasing the MODWAY OFFICE CHAIR！

Before you start, here is some helpful advice:

1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step

instructions.

2.Owing to the size and weight of the office chair, we recommend that it is assembled by two adults, on a carpeted

or padded area, in the room that it is intended for. Approximate assembly time: 15 minutes.

3.Please do not use any tools other than those provided or recommended in these instructions.

4.Please do not throw away any of the packaging or instructions until you have checked all the components and

hardware and the furniture is fully assembled.

5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the

components from time to time, so please save the tools that have been provided.

6.Please keep all pieces out of reach of small children.

Component:

Chair Body

Customer Service 908-368-1025︱www.modwayfurniture.com

OFFICE CHAIR

Cylinder

Chair Base

No Hardware & Tool required for this Chair

Decoration Cover

Caster

Page 1 of 3

Table of Contents

Need help?

Do you have a question about the EEI-2126 and is the answer not in the manual?

Page 1 EEI –2126/2127 OFFICE CHAIR Thank you for purchasing the MODWAY OFFICE CHAIR！ Before you start, here is some helpful advice: 1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step instructions.
Page 2 EEI –2126/2127 OFFICE CHAIR STEP 1: Please put the Chair Base (D) on a carpeted or padded surface. Insert 1pc of Castor (C) into the Chair Base (D) as shown by hand. Repeat the same steps for the remaining 4pcs of Castor (C). STEP 2: Flip the assembled Chair Base (D) with Castors (C) on the floor.
Page 3 EEI –2126/2127 OFFICE CHAIR STEP 3: Carefully take out Chair Body (A). Line up the hole on the bottom of Chair Body (A) with the top end of Cylinder (B), drop the Chair Body (A) onto the Cylinder (B) naturally. Rotate a few times to test security. Assembly is complete.

Eei-2127