Panasonic ES-MT22 Operating Instructions Manual page 53

4
Clean with running water�
• Splashing is reduced by
rinsing the shaver in sonic
vibration cleaning mode.
• Hold the ion plate under
running water and rinse off the
hand soap.
• Also wash the cap in running water after using
MOISTURIZING mode and PURIFYING mode.
• After rinsing with water, shake the shaver up and
down for a few times to remove excess moisture and
then wipe off any drops of water with a dry cloth.
5
Dry the outer foil section,
the shaver, and the
trimmer completely�
• Allow the shaver to dry in the
shade, avoid direct sunlight.
6
Lubricate the shaver�
It will keep the movement of the
blades smooth and maintain a
comfort shave.
1. Apply one drop of oil to each
of the system outer foils.
2. Raise the trimmer and apply a drop of oil.
3. Switch the shaver on, and run it for approximately
five seconds.
4. Switch off the shaver, and wipe off any excess oil
from the system outer foil with a soft cloth.
Notes
• Do not use any kitchen or bathroom detergents other
than hand soap.
Doing so may cause malfunction.
• Be careful not to hit the main body on the sink or any
other object while draining the water. Failure to do so
may cause malfunction.
• Do not wipe with thinners, benzine, alcohol etc.
Doing so may cause malfunction, cracking or
discoloration of the parts.
Wipe with diluted soapy water.
Cleaning with the brush
Remove the outer foil section and the inner blades.
(See page 54.)
Do not use any brush other than the supplied one.
►Cleaning with the long brush
Clean the foil frame, system
outer foil, the main body, ion
plate and the trimmer using
the long brush.
53