Table of Contents
Advertisement
When the battery capacity is low
The charge status lamp ( ) blinks once every second
when operating the shaver.
• The appliance beeps twice after switched off.
• You can shave once for 3 minutes after the charge
status lamp ( ) blinks (This will differ depending on
usage.)
Abnormal charging
The charge status lamp ( ) will blink twice every second.
Notes
• After charging is completed, turning the power switch
ON with the shaver plugged in will cause the charge
status lamp ( ) to light up and then turn off after 5
seconds.
This shows that the shaver is fully charged.
• When charging the shaver for the first time or when it
has not been in use for more than 6 months, the
charging time may change or the charge status lamp
( ) may not glow for a few minutes. It will eventually
glow if kept connected.
44
• Recommended ambient temperature for charging is
10 °C – 35 °C. It may take longer to charge, or the
charge status lamp ( ) will blink quickly and the
battery may fail to charge properly in extremely high
or low temperatures.
• If there is noise from the radio or other sources while
using or charging the appliance, move to a different
location to use the appliance.
Skin (allergy) test procedure
This is a simple patch test (skin test) to check whether any
adverse reactions will be caused to the skin in advance.
To prevent skin problems, check the compatibility
of the lotion you are using and the main body�
1. Clean the patch test area (inner arm) with soap and
water, and dry it with a towel.
2. Apply lotion to the test area.
3. In MOISTURIZING mode, hold the ion plate against
the test area. (See page 48.)
• Hold for approximately 10 seconds with the cap
attached to the main body.
• If there is any discomfort, turn the ion level to "LOW."
Advertisement
Chapters
Table of Contents
