Operation; Switching On And Off; Setting The Oscillating Speed; Fitting The Sanding Sheet - Parkside PSS 270 C3 Translation Of The Original Instructions

Operation

Switching on and off
Switching on
♦ To switch the tool on, slide the ON/OFF
switch 1 forwards.
Switching off
♦ Slide the ON/OFF switch 1 backwards to
switch the tool off.

Setting the oscillating speed

You can set the desired oscillating speed using the
speed selector q as required. The required speed
depends on the material being processed and can
be determined through practical tests.

Fitting the sanding sheet

WARNING!
► Always remove the plug from the mains power
socket before carrying out any work on the
tool.
NOTE
► Before fitting a new sanding sheet 0, remove
any dust and dirt from the sanding plate 9.
Sanding sheets with Velcro
♦ Position the sanding sheet 0 flush on one side
of the sanding plate 9.
♦ Then lay the sanding sheet 0 onto the sanding
plate 9 and press it firmly into place.
Sanding sheets without Velcro
♦ Open the two clamping levers 8 by pressing
them slightly outwards and then carefully pulling
them upwards out of the catches.
♦ Push one end of the sanding sheet 0 under the
open clamping bar 7 and clamp it firmly in
place with the clamping lever 8.
♦ Follow the same procedure at the other end.
Different materials require different grain sizes. You
can find out which grain is suitable for which work
in our non-binding recommendations in "Work
instructions, tips and tricks".
│ GB │ IE
■ 6

Extracting dust

WARNING! RISK OF FIRE!
► When working with power tools that have a
dust collector 4 or can be connected to a
vacuum cleaner via the vacuum cleaner
adapter, there is a risk of fire! In unfavourable
conditions, e.g. when sparks are flying while
sanding metal or metal residues in wood,
wood dust in the dust bag (or in the bag of
the vacuum cleaner) can spontaneously ignite.
This is a particular risk if the wood dust is
mixed with paint residues or other chemicals
and the workpiece has become hot after
being worked for a long time. Therefore,
avoid allowing the workpiece or tool to over-
heat and always empty the dust collector 4
or the dust bag of the vacuum cleaner before
taking a break from work.
Wear a dust mask!
Dust extraction with dust collector
Connection
♦ Push the dust collector 4 onto the appliance.
Turn the dust collector 4 to the
lock it in place.
Removal
♦ Turn the dust collector 4 towards the
Pull the dust collector 4 off the appliance (see
detailed illustration on fold-out page).
NOTE
► To ensure optimum extraction, empty the dust
collector 4 regularly.
♦ To do this, remove the dust collector 4 from
the appliance as described above. To do this,
open the dust collector 4 by pressing on the
release button 3 and pulling off the rear part
(see detailed illustration on fold-out page).
Now remove the dust bag. Clean the dust bag
thoroughly by tapping it out.
symbol to
symbol.
PSS 270 C3