Electrical Requirements; Parts And Features; Turntable - KitchenAid YKEMC307 Use & Care Manual

Electrical Requirements

The microwave oven is connected to a 110-volt side of the 240-
volt circuit required for the lower oven. If the incoming voltage to
the microwave oven is less than 110 volts cooking times may be
longer. Have a qualified electrician check your electrical system.
GROUNDING INSTRUCTIONS
For all cord connected appliances:
The microwave oven must be grounded. In the event
of an electrical short circuit, grounding reduces the
risk of electric shock by providing an escape wire for
the electric current. The microwave oven is equipped
with a cord having a grounding wire with a grounding
plug. The plug must be plugged into an outlet that is
properly installed and grounded.
WARNING:
Improper use of the grounding plug can
result in a risk of electric shock. Consult a qualified
electrician or serviceman if the grounding instructions
are not completely understood, or if doubt exists as to
whether the microwave oven is properly grounded.
Do not use an extension cord. If the power supply cord
is too short, have a qualified electrician or serviceman
install an outlet near the microwave oven.
For a permanently connected appliance:
This appliance must be connected to a grounded,
metallic, permanent wiring system, or an equipment
grounding conductor should be run with the circuit
conductors and connected to the equipment
grounding terminal or lead on the appliance.
SAVE THESE INSTRUCTIONS

PARTS AND FEATURES

1
CONVERSION
2
3
4
5
6
1. Lower Oven Control
(on some models)
2. Door Safety Lock System
3. Microwave Oven Light
4. Glass Turntable
5. Metal Shielded Window
6. Door Handle
7. Microwave Oven Control
Panel

Turntable

1
2
3
4
1. Turntable
2. Hub
3. Support
4. Shaft
The turntable rotates in both directions to help cook food more
evenly. Do not operate the microwave oven without the turntable
in place. See "Assistance or Service" to reorder any of the parts.
To Install:
1. Remove tape from the hub.
2. Place the support on the oven cavity bottom.
3. Place the turntable on the support.
Fit the raised, curved lines in the center of the turntable
bottom between the three spokes of the hub. The rollers on
the support should fit inside the turntable bottom ridge.
ENTER TEMP CRISP COOK
AUTO SENSOR DEFROST
START ? P REHEAT TIMER
HR 1 3 2 LBS MIN NO. SEC
PWR
IN.
OZ
CONVECT
FULL FULL CONVECT
BROIL BROIL CRISP
MEAL QUICK QUICK
PREHEAT PREHEA
8. Quartz Broil Element
(hidden in ceiling, near door)
9. Convection Element and Fan
(not visible - on some models)
10. Cooking Guide Label
11. Removable Turntable Support
Parts and Features not shown
Oven Vent (behind door handle)
7
8
9
10
11
5