Table of Contents
Advertisement
Remove limescale with a cloth soaked in vinegar.
3.
Then wipe with clean water and rub dry with a soft
cloth (including under the door seal).
21 Drying
To prevent residual moisture, dry the cooking compart-
ment following operation.
ATTENTION!
If there is water on the cooking compartment floor
when operating the appliance at temperatures above
120 °C, this will damage the enamel.
Do not use the appliance if there is water on the
▶
cooking compartment floor.
Wipe away any water on the cooking compartment
▶
floor before operation.
21.1 Drying the cooking compartment
You can dry the cooking compartment by hand or use
the drying function.
Allow the appliance to cool down.
1.
Remove dirt from the cooking compartment.
2.
Wipe away the water in the cooking compartment.
3.
Dry the cooking compartment.
4.
Leave the appliance door open for one hour to
‒
dry the cooking compartment by hand.
22 Appliance door
To clean the appliance door thoroughly, you can disas-
semble the appliance door.
22.1 Removing the door cover
The stainless steel inlay in the door cover may discol-
our. Remove the door cover in order to clean it and the
stainless steel inlay, or to remove the door panes.
Open the appliance door slightly.
1.
Press down on the left- and right-hand sides of the
2.
door cover.
Remove the door cover and carefully close the ap-
3.
pliance door.
In order to dry the cooking compartment, leave the
4.
appliance door open in the detent position (approx.
30°) for approx. one hour.
In order to use the drying function, set the drying
‒
function.
→ "Setting the drying process", Page 29
Setting the drying process
Allow the appliance to cool down.
1.
Remove coarse dirt from the cooking compartment
2.
and wipe away moisture from the cooking compart-
ment floor.
3.
Press
.
In the operating mode menu, press the drying oper-
4.
ating mode.
The duration is set to 10:00 min. and cannot be
changed.
Press
to start the drying function.
5.
a The appliance starts to dry and the duration counts
down.
Once the duration has elapsed:
6.
A message appears in the display.
‒
Press
to silence the audible signal before
‒
it is due to end.
Press
to switch the appliance off.
‒
22.2 Removing the door panes
WARNING ‒ Risk of injury!
Scratched glass in the appliance door may develop
into a crack.
Do not use any harsh or abrasive cleaners or sharp
▶
metal scrapers to clean the glass on the oven door,
as they may scratch the surface.
The hinges on the appliance door move when the door
is opened and closed, which could trap your fingers.
Keep your hands away from the hinges.
▶
Components inside the appliance door may have sharp
edges.
Wear protective gloves.
▶
Requirement: The door cover has been removed.
Undo and remove the screws on the left and right of
1.
the appliance door.
Place a folded-up tea towel in the appliance door.
2.
Drying en
29
Advertisement
Table of Contents
