Toro Multi-Pro 1200 Operator's Manual page 19

Flowmeter
The flowmeter measures the flow rate of the fluid for use
by the Spray Pro system (Fig. 17).
Boom Valves
These valves turn the three booms on or off (Fig. 17).
Boom Bypass Valves
The boom bypass valves redirect the fluid flow for a boom
to the tank when you turn off the boom section. You can
adjust these valves to ensure that the boom pressure
remains constant no matter how many booms are on. Refer
to Adjusting the Boom Bypass Valves, page 22.
Agitation Control Valve
This valve is located on the right side of the tank (Fig. 18).
Turn the knob on the valve to the 9 o'clock position to turn
on the tank agitation and to the 3 o'clock position to turn
off the tank agitation.
2
1
Figure 18
1. Agitation control valve
For agitation to work, the pump must be on and the engine
must be running above an idle. If you stop the sprayer and
need agitation on, place the range selector in the Neutral
position, set the parking brake, press the accelerator pedal
to the floor, and turn the neutral engine speed control on.
Pressure Gauge
The pressure gauge is located to the right of the tank
(Fig. 18). This gauge shows the pressure of the fluid in the
system in psi and kPa.
Pump
The pump is located near the front of the tank on the right
side (Fig. 19).
All manuals and user guides at all-guides.com
2. Pressure gauge
19
2
Figure 19
1. Pump
Tank Drain Knob
The tank drain knob is located on top of the tank (Fig. 20).
Turn the knob counterclockwise to drain the tank.
1
Figure 20
1. Tank drain knob
Tank Cover
The tank cover is located in the center of the top of the tank
(Fig. 21). To open it, turn off the engine, then turn the front
half of the cover to the left and swing it open. You can
remove the strainer inside for cleaning. To seal the tank,
close the cover and rotate the front half toward the right.
2
Figure 21
1. Tank cover
1
2. Grease fitting
1
2. Anti-siphon fill receptacle