Table of Contents
Advertisement
Installation
Electrical Connection
3-Wire
WARN ING
ELECTRICAL SHOCK HAZARD
To avoid risk of electrical shock, personal injury
or death; verify your appliance has been properly
grounded in accordance with local codes or in
absence of codes, with the National Electrical Code (NEC) ANSI/
NFPA-70 – latest edition.
See Electrical Requirements information. Where local codes do not permit grounding through neutral, use a 4-wire power supply
cord. The cord or conduit must be secured to the range with the strain relief bracket. The electrical connection is made at the
terminal block, which is located behind the access door on the back of the range.
1
Remove access door.
3
Feed supply cord up through hole in bottom
of range back.
WAR NI NG
ELECTRICAL SHOCK HAZARD
To avoid risk or electrical shock, personal injury
or death; grounding product to the frame of the
unit may or may not be permitted through your
local codes. If ground to the frame is not permitted then a 4
conductor power cord must be used.
2
Remove supply cord strain relief
bracket and three supply cord mounting screws
4
Attach line #1 (red) and line #2 (black) leads to
outside terminal. Attach neutral wire (white) to
15
center terminal on the terminal block.
on terminal block.
Advertisement
Table of Contents
