3.5
Installing the start number plate
3.6
Removing the seat
Caution
Danger of burns The voltage regulator gets very hot when the vehicle is driven.
–
Allow the voltage regulator to cool down before performing any work.
3.7
Mounting the seat
–
Position the brake line in holders
plate.
–
Position the start number plate. Mount and tighten screw
The holding lugs engage in the fender.
F01525-10
–
Remove screw
F01533-10
–
Raise the rear of the seat, pull the seat back, and lift it off.
H02218-10
–
Mount the front of the seat on the collar bushing of the fuel
tank, lower the seat at the rear, and push the seat forward.
–
Make sure the seat is latched in place correctly.
H02218-11
A
on the start number
1
.
WORK 3
1
.
17