Device Payload - IME Milesight EM300 Series User Manual

2. Drill the holes according to the marks and screw the wall plugs into the wall.
3. Mount the EM300 to the wall via mounting screws.
4. Cover the mounting screws with screw caps.
5. For leak detection senor, install the probe/cable to the place where liquid may leak;
for magnet switch sensor, install the magnet beside the door/window; for pulse counter, connect
the wires to a pulse meter.
Note: For SLD sensor, please ensure the metal pins of the probe are flat on the floor; for ZLD
sensor, the cable can't be twined or accumulated together. The probe or cable of water leakage
sensor should be placed in an area of concern where water from a leak would likely accumulate.

5. Device Payload

All data are based on following format(HEX), the Data field should follow little-endian:
Channel1 Type1
1 Byte 1 Byte
Data1 Channel2
N Bytes 1 Byte
Type2 Data2 Channel 3
1 Byte M Bytes 1 Byte
www.ime.de
...
...
21