Operating Netcommand-Controlled Devices - Mitsubishi Electric Unisen 154 Series Owner's Manual

NetCommand Setup, continued
Adding or Removing Device Keys from
NetCommand Control
After performing initial setup, you can add or remove
individual keys under NetCommand control.
1.
Switch the TV to the device. Press
the device's icon, and press ENTER.
2.
Open the Inputs menu and highlight the Learn icon.
3.
Learn screen displays:
When the
To add keys:
•
under "Initial NetCommand Setup" on the
opposite page.
• To delete keys:
you wish to delete and press CANCEL on the
TV's remote control. Clears the check mark.
Downloaded From TV-Manual.com Manuals
5. NetCommand IR Control (265 Series)
INPUT, highlight
Continue as described earlier
Highlight the name of the key
Get other manuals https://www.bkmanuals.com
Operating NetCommand-Controlled
Devices
Controlling Most Device Types
As an example of NetCommand control, if you are
watching your cable box and you wish to tune to the
next channel higher, press CHANNEL UP. NetCommand
then sends the "learned" channel-up control signal to
the cable box.
1.
Perform NetCommand setup for the device as
described in this chapter.
2.
When you wish to use the device, press
3.
Highlight the icon for the device.
4.
ENTER to switch the TV to the device.
Press
Note: if you have set up automatic input switching for
the A/V receiver, the A/V receiver will automati-
cally switch to the correct input for the device.
5.
To operate the device using the
control, press the TV key to put the remote control
into TV mode.
6.
Point the remote control at the
and press the key for the desired function.
7.
TOOLS key to access additional key func-
Press the
tions you may have "learned" for the device.
For assistance call 1(800) 332-2119
63
INPUT.
TV's remote
TV (not the device)