E-Bike EKD01 Manual page 7

lowest power, and 5 is the highest power. When the monitor is powered on, the
default setting is Gear 0.
following figure:
③ Headlight/backlight switch
Turn on the light
: Press and hold "+"
lights up, and the brightness of the display dims.
Turn off the lights: When the light is on, press and hold the "+" key, the headlight
indicator becomes dimmed, and the display brightness becomes brighter.
The headlight switch interface is shown in the figure below:
④ Boost mode
In any gear, long press
entering boost mode, the icon ""
mode icon
, boost
The interface is shown in the following figure:
In boost mode,
is lower than 6km/h, release the "-" to exit the boost state. If there is no
operation within 5 seconds under static, it will automatically jump to 0 gear.
gear level selection screen is shown in the
The
when
"-" to enter boost mode, the speed is
is in dynamic, release the button" - "exit boost
disappears, and the speed returns to zero.
the indicator is displayed dynamically. When the speed
7/20
light is off
the , the
headlight indicator
6km/h
, when