Cleaning Modes - Shark Navigator LIFT-AWAY ADV LA300 Series Owner's Manual

WHOLE-HOME CLEANING
POWER/SURFACE SWITCH
Select surface setting:
O Off
I Hard Floor
For hard floors and small area rugs.
II Carpet
For carpets.
NOTE: Brushroll spins in all modes
BRUSHROLL INDICATOR LIGHT
INDICATOR LIGHT
WHAT DOES THE BRUSHROLL INDICATOR LIGHT MEAN?
Solid Green: The brushroll is spinning and working as intended.
Solid Red: There is a jam in the brushroll area. Turn off and unplug the vacuum and remove any
blockages in the nozzle.
Flashing Red: The motorized floor nozzle is overheating. Turn off the vacuum, unplug it, and
remove any blockages. Let the vacuum cool down for at least 60 minutes before restarting.
See Troubleshooting section for more information.
NOTE: For deep carpet cleaning per ASTM F608 (embedded dirt in carpets) set to MAX suction and use setting II, Carpet.
s h a r kc l e a n . c o m
SETTINGS
SUCTION CONTROL
The Suction Control Slider located on the handle
allows you to adjust the suction depending on the
floor type.
MIN: to reduce suction and increase
maneuverability on carpets.
MAX: to increase suction on hard floors.
WHOLE-HOME CLEANING

CLEANING MODES

UPRIGHT MODE
To engage Brushroll, turn power on,
select a surface setting, then step on
floor nozzle and tilt handle back.
ABOVE-FLOOR—HANDLE
Press the Handle Release button and pull
up on the handle to detach it from the wand.
ACCESSORIES—HANDLE
Attach an optional cleaning accessory to
handle or wand.
NOTE: All accessories are compatible with both the wand and the handle. Included accessories will vary by model.
LIFT AWAY MODE
Step on the pedal on the floor nozzle
to lift off the pod.
Wand
Release
ABOVE-FLOOR—WAND
Press the Wand Release button and pull
up on the wand to detach it from the pod.
ACCESSORIES—WAND
s h a r kc l e a n . c o m