Panasonic TOUGHBOOK CF-18 Service Manual page 52

7.2.18. Setting the Battery Pack and the HDD Pack
1. Set the HDD in the HDD Case and fix it using the two
Screws<A>.
HDD Case B
HDD FPC
HDD
Heater
<A>
HDD Case A
2. Open the HDD Cover and set the HDD Pack.
! Assembly of the HDD ASSY
HDD GUIDE PIN
Crosswise:
HDD Guide -3 to +3 mm of
the center of the
Pin Plate
HDD Guide
Pin Plate
Lengthwise:
Adheisive
Avoid coming over
Tape
the HDD Guide
Pin Plate.
Crosswise:
-1 to +1 mm of
the center of
the HDD Guide Pin Plate
Lengthwise:
-0.5 to +0.5 mm
ofthe center
HDD Guide
of the HDD Guide
Plate Spacer
Pin Plate
FPC Assy
0~0.5mm
FPC(HDD) HDD Spacer C
0~0.5mm
Hooks
Hooks
<A>
Attach under the FPC
(between the FPC
and the HDD).
Remove the Release Papers
(three) and attach them.
0~1mm
Set the FFC to the pin of the HDD,
and connect the Connector of the Heater
to the FFC, and then attach them.
HDD GUIDE PIN Assy
inserted into pins
Insulation Parts
Cover the sensor
of the FPC.
0~0.5mm FPC ASSY
5–1mm
Insulation
Heater
Parts
HDD
3. Open the Battery Cover and set the Battery.
Screws<A>: DFHE5025XA
2
Battery Pack
HDD Cushion Spacer
Set the FPC under the Damper.
Heater Insulation
Sheet
Avoid coming over the
conductive part (metallic part)
of the Heater.
0~1mm
HDD Case A
0~1mm
Attach the HDD Case A,
and then connect it.
(Four joints)
Sub material:
PET TAPE 2
(10 mm width x 3 cm)
0~0.5mm
Safety Working
Match to the
Fold it back once
center of the
and adjust the length.
HDD Damper.
0~5mm
Insulation Parts
Ensure you can see it
5–1mm
from the slit space of
the HDD after assembly. Press and
hold it
Revision Label
vertically,
and screw it.
7-33
1
3
HDD Pack
HDD Damper
HDD Case B(Assy)
0~0.5mm
Attach on the surface.
HDD Case
Tab
Attach on the inner
side of the HDD
Case A.
0~0.5mm
Shield Sheet
(For GPS)
Completely cover the hole of the Case.
Press and hold the leveled part, and attach it.
Set the Hooks of the HDD Case A inside.
Screw
Use the jig.