Panasonic TOUGHBOOK CF-18 Service Manual page 30

7.2.3. Assembling GPRS Antenna PCB, LAN1-BT PCB, LAN2-BT PCB, Wide Area Aux
PCB, and Pen Holder
1. Fix the Pen Holder using the 2 Screws. <b>
2. Fix the Wide Area Aux PCB using the 2 Screws. <a>
3. Fix the LAN2-BT PCB using the 2 Screws. <a>
4. Fix the LAN1-BT PCB using the 2 Screws. <a>
5. Fix the GPRS Antenna PCB using the 2 Screws. <a>
Screws <a> : DFHE5025XA
Screws <b> : DRHM5025YA
! Line processing of Antenna Cable
Screw<a>
GPRS Antenna PCB
Screw<a>
Screw<a>
LAN2-BT Antenna PCB
Screw<a>
Detail of "C"
Be free of overhang..
Safety Working
Safety Working
Detail of "A"
Be free of overhang..
A
Cable Cushion
Bundle and wind 3 cables.
Attach it to the inner
side of the right rib.
Cable Cushion
C
0~1mm
0–3mm
Sheet(For EMI)
Tape
Bundle and wind 2 cables.
Wide Area
Pen
Aux PCB
LAN1-BT
<a>
Antenna PCB
<a>
<a>
<a>
Safety Working
Safety Working
Cable Cushion
Insert this between two ribs after pasting
Cable Cushion.
Be free of overhang..
Detail of "D"
Insert cables between four pins.
Hook it.
Ensure the white Cable is coming out
by 31 cm or more from the right edge (
of the Front Case.
More than 31cm from
7-11
<b>
<b> Pen Holder
<a>
<a>
LAN2-BT
Antenna PCB
<a>
GPRS
Antenna PCB
<a>
Detail of "B"
Be free of overhang..
B B
Screw<a>
LAN1-BT
Antenna PCB
Screw<a>
Screw<a>
Wide Area Aux
PCB
Screw<a>
D
)