Panasonic TOUGHBOOK CF-18 Service Manual page 51

! Cautions for Setting the Keyboard
LCD CABLE
Connect the Connector to the part
with dotted frame.
(Note
Hold the Connector part when
connecting/disconnecting.
Do not bend at the foot
of stiffening plate.)
Touch Panel model
Connector for the KBD FFC.
Digitizer Model
Connector for the KBD FFC.
Safety Working
Connect the KBD FFC.
! Putting of the Palm Rest ASSY
3~5mm
Windows Logo Label
Remove the two-sided tape on the back side and attach it.
Attach and apply the load 30 to 40N (3.0 to 4.0 Kgf).
Release Paper
Keyboard
KBD Tape
Lengthwise:
Match to the center line.
Crosswise:
Match to the end of the KBD.
8~
10mm
0~1mm
Push the Cushion of the jig into the part with dotted frame ("A"),
and press on the jig until the both ends of jig fit to the Top Case ("B").
Screw
Screw
Screw
intel Label
Energy Star Label
Remove the Release Paper, and then attach the Palmrest Assy.
Palm rest Assy
Keyboard
KBD Tape
KBD Tape
Lengthwise:
Match to the center line.
Crosswise:
Match to the end of the KBD.
KBD Tape
0~1mm
Lengthwise: Match to the top end of the KBD.
HINGE COVER
Jig
A B
B KBD CNT LID CUSHION
KBD Connector Cover
KBD Plate(L)
Set it and then press it using the jig.
Fix from the
(Insert the Hook first.)
Hinge side.
Before setting the KBD Plate (L)
and the KBD Plate (R),
press on the positions (four)
with the two-sided tapes.
30N(3.0Kgf)
5~7mm
3~5mm
4~6mm
LED Waterproof Sheet
Match to the upper left corner. 0 to 0.3 mm
Avoid running over when attaching.
Don't overflow.
7-32
KBD Connector Cover
Apply the load to attach. 30 to 40N
(3.0 to 4.0 Kgf)
KBD Connector Cover
0–0.5mm
KBD Connector Cover Sheet
Screw
Screw
Screw
Screw
KBD Plate(R)
Fix from
the Hinge side.
Set the four Hooks.