Advertisement
The manual controls are located on the left side of the fireplace.
You have the following controls:
1. Plug in your electric fireplace.
2. Make sure the main power ON/OFF
switch is ON! The remote control will
NOT work if the main power switch is
OFF.
3 When operating the remote control, it
must be pointed towards the front of the
unit.
4. The ON/OFF button at the below right of the
remote is the main ON/OFF power button
(Figure 5). Pressing this button activates
the power to the unit.
5 Presss the
button to cycle through LO, HI
and OFF.
6 To adjust the flame height and ember bed
brightness, press the "
To increase the flame height and ember
bed brightness, press the "
the flame height and ember bed brightness, the"
button. There are five levels of flame effects.
7. To turn off the fireplace, press the
ON/OFF button once. NOTICE: This
remote control must remain within 8
meters or 26 feet of the fireplace to be
effective.
1. Power ON/OFF: Power to the unit
2. Flame brightness controls: Allows you to adjust
the flame to suit your mood. Press
increase flame brightness and
flame brightness. You must press the
Several times to see the full flame effect.
3. Low heat: 700 watts
4. High heat: 1350 watts
Please note: The heater touch panel control must
be pressed 2 times to achieve high heat.
5. Heater Timer: Allows you to leave your heater
on while you sleep with an automatic timer for
shut off. You can set your heater to be on for
1/2 hour increments starting at a 1/2 hour up to
a maximum of 7-1/2 hours press once for each
1/2 hour increment. Afteryou reach 7-1/2 hours
the next press will shut off the feature.
"or "
" buttons.
" button. To decrease
"
to
to decrease
button
13
Advertisement
