Table of Contents
Advertisement
3.
Expand your Chassis tree item. MAX lists all devices installed in the chassis. Your
default device names may vary.
Note
installed devices. If the device is still not listed, power off the system, ensure
the device is correctly installed, and restart.
Installing the NI FlexRIO Adapter Module
Skip this step if you are not using an adapter module.
Note
1.
Gently insert the guide pins and the high-density card edge of the NI FlexRIO adapter
module into the corresponding connectors of the NI FlexRIO FPGA module, as shown in
the figure below.
1
1. NI FlexRIO Adapter Module
2. Captive Screw
3. Guide Pin
The connection may be tight, but do not force the adapter module into place.
2.
Tighten the captive screws on the NI FlexRIO adapter module to secure it to the
NI FlexRIO FPGA module. NI recommends using the laser-tipped screwdriver (part
number 748677-01) included in the NI PXIe-7975R packaging.
3.
Launch LabVIEW to begin configuring your NI FlexRIO system.
Note
adapter module will not appear in MAX.
If you do not see your hardware listed, press <F5> to refresh the list of
Figure 5. Installing the NI FlexRIO Adapter Module
2
3
MAX only recognizes FPGA modules that are in the chassis. Your
NI PXIe-7975R FPGA Module Getting Started Guide | © National Instruments | 9
P X
I - 1
0 0 0
B
4. PXI/PXI Express Chassis
5. NI FlexRIO FPGA Module
4
5
Advertisement
Table of Contents
