Advertisement
Assemble the wheel support to the bottom of the cart
using eight 5/16" x 3/4" truss head bolts and 5/16"
nylock nuts as shown in figure 4. Heads of bolts go on
the inside of cart. Tighten.
5/16" x 3/4"
TRUSS HEAD BOLT
WHEEL
SUPPORT
5/16"
NYLOCK
_
NUT
FIGURE 4
To prevent accidental tipping during the following
assembly procedures, lower the cart to rest upside
down, with the wheel support facing up, as shown in
figure 5.
Align the latch stand bracket so that the tab is at the
rear. Fasten the bracket to the rear set of holes at the
front of the cart using two 1/4" x 5/8" hex bolts, 1/4"
flat washers and 1/4" nylock nuts. Use the 1/4" flat
washers as shims between the bracket and the cart
bed. Make finger tight. See figure 5.
LATCH
STAND
BRACKET
1/4" NYLOCK NUT
(Tab at rear)
/
1/4" FLAT
\
1/4" x 5/8"
HEX BOLT
*
Position the rear tongue on the wheel support and the
latch stand bracket. Assemble the axle through the
wheel support and the tongue. See figure 6.
iMPORTANT:
Make sure the tongue is securely locked
to the latch stand bracket by the latch lock lever.
AXLE
TONGUE
FIGURE 6
o
o
Assemble a spacer tube onto each end of the axle as
shown in figure 7.
Assemble a 1" flat washer, a wheel (valve stem facing
out), and another 1" flat washer onto the axle as
shown in figure 7. Secure the wheel with a cotter pin,
spreading the ends so that a hub cap can fit over the
pin. Assemble the hub cap by pressing it onto the flat
washer. Repeat on other end of axle.
SPACER TUBE
WHEEL
\
1" FLAT
\
WASHER
\
AXLE
T
HUB CAP
COTTER PIN
1" FLAT
WASHER
FIGURE 7
FIGURE 5
Call 1-866-576-8388
for missing parts or assembly help
DO NOT RETURN TO STORE
9
Advertisement
