Download Print this page

Craftsman CHIP-N-VAC 486.24717 Operator's Manual page 18

Professional chip-n-vac

Advertisement

CUSTOMER
RESPONSiBiLiTiES
Read and follow the maintenance schedule and the maintenance procedures listed in this section.
MAINTENANCE
SCHEDULE
Fill in dates as you
complete regular service.
Check for loose fasteners
X
Check soft vinyl boot
X
Check tire pressure
X
Check engine oil level
X
Lubricate
X
Clean
X
X
Maintain engine per instructions below and in engine manual.
Service Dates
BEFORE
EACH USE
CHECK FOR LOOSE FASTENERS
Make a thorough visual check of the Chip-N- Vac
for any bolts and nuts which may have loosened.
Retighten any loose bolts and nuts.
CHECK VINYL BOOT
Check the soft vinyl boot (on front of hard top) for
wear. Replace if worn or damaged.
CHECK TIRE PRESSURE
Check tire pressure regularly. Recommended tire
pressure is 12-14 Lbs.
CHECK ENGINE OIL LEVEL
Check oil level before each use. Maintain engine oil as
instructed in the separate engine manual.
LUBRICATION
At the beginning of each season, lubricate the latch,
latch pivot bolt, and the axle where the hitch tongue
pivots, with a light machine oil.
At least once a season, grease or oil the wheel
bearings. Use automotive wheel bearing type grease
or 20 weight oil.
WARNING:
Always stop engine and
disconnect spark plug wire before cleaning,
lubricating or before performing any repairs
or maintenance.
ENGINE
MAINTENANCE
Check oil level before each use. Maintain engine oil
as instructed in the separate engine manual.
Service air cleaner every 25 hours under normal
conditions. Clean every few hours under extremely
dusty conditions. Poor engine performance and
flooding usually indicates that the air cleaner should
be serviced. To service the air cleaner, refer to the
separate engine manual.
The spark plug should be cleaned and the gap
reset once a season. Spark plug replacement is
recommended
at the start of each season. Check
the engine manual for correct plug type and gap
specifications.
CLEANING
Make sure the cart, the side and front panels and
top are cleaned after each use. Grass clippings and
leaves left in the cart will mildew and cause damage if
not cleaned out.
Clean the engine regularly with a cloth or brush.
Keep the cooling fins on the engine housing clean
to permit proper air circulation which is essential to
engine performance and life. Be sure to remove all dirt
and debris from muffler area.
1 8
Call 1-866-576-8388
for missing parts or assembly
help
DO NOT RETURN TO STORE

Advertisement

loading