Advertisement
BEFORE
PROCEEDING,
look in the fold-out sheets included with this manual
to find templates
for Sears mower decks, if written instructions
are printed on the
template,
follow those instructions
instead of the instructions
in this manual.
ASSEMBLING
THE DECK ADAPTER
(#62468)
TOTHE
MOWER
DECK
NOTE: Not all of the parts in the deck adapter hardware
package will be needed for your particular fit up.
Contents
of Hardware Pack for Deck Adapter:
Key
Qty.
Description
A
2
Hex Bolt, 5/16" x 1-1/4"
B
4
Hex Bolt, 1/4" x 3/4"
C
2
Carriage Bolt, 5/16"x 3/4"
D
3
Nylock Nut, 5/16"
E
5
Nylock Nut, 1/4"
F
6
Flat Steel Washer, 1/4" Std.
G
12
Flat Washer, 5/16" Std.
H
5
Nylon Washer
I
1
Mounting Strap
J
1
Angle Bracket
K
1
Mounting Bracket
Remove the mower discharge deflector from your
mower deck. Save the deflector and hardware for
remounting deflector.
CAUTION:
Mower deflector must be
replaced when Chip-N-Vac deck adapter
is removed. Do Not operate mower
unless adapter or deflector is in place and
properly mounted.
Identify your mower deck (see fold outs) and cut
out the correct discharge opening template for your
mower deck size. If there is no template for your deck
size you can make your own template by marking
around a piece of cardboard held against the edge of
the discharge opening.
Tape the template to the face of the adapter, locating
template approximately
1/2" from front and 1/4" down
from top of adapter. Keep as close to top as possible.
See figure 23. Mark outline of template on face of
adapter using white crayon, nail or scriber. Drill a
starting hole inside the outline, then use a saber saw
or key hole saw to cut out the opening.
See figure 23.
_tA
D
E
1/4" DOWN
IMPORTANT:
Keep cut-off
as close
to
the top edge as possible.
112" FROM FRONT
FIGURE
23
1 4
Call 1-866-576-8388
for missing parts or assembly
help
DO NOT RETURN TO STORE
Advertisement
