HP A6829A User's Manual And Service Manual page 78

Installing the A6829A Adapter
Using the EFI Flash Utility
5 0x1000
LSI Logic, Inc. SYMC1010 Ultra160 66Mhz SCSI
6 - Refresh
Which chip/adapter (0 to quit)?
The main window allows you to choose the SCSI chip corresponding to
the path where you want to perform the selected tasks. Dual channel
cards display two entries (one for each SCSI chip) on this screen.
In the aforementioned example, the system has three HBAs - one each on
the 0x15, 0x3F, and 0x16 buses. The HBA on bus 0x3F is a dual-channel
HBA (func 0x00 and func 0x01) with flash memory part number
Am29F010. Since both the channels of a dual channel board share the
same flash memory, only one of the paths needs to be chosen. If separate
updates are performed through both the paths, the flash memory is not
affected.
NOTE Each update overwrites the existing contents of the flash memory.
The segment value of the HBA corresponding to Choice number 5 is
0x01. This indicates that the HBA resides on PCI segment 1. The other
HBAs reside on PCI segment 0, as the segment value for other HBAs is
0x00.
The SYMC1010 following LSI Logic, Inc. indicates that the HBAs use
the 53C1010 LSI SCSI chip, which is supported by this EFI utility.
If a device does not contain an LSI Logic SCSI chip supported by the EFI
utility, the lines listing the chip numbers do not appear in the display.
The HP A6829A SCSI HBA is based on the LSI Logic 53C1010 SCSI
chip.
At the Which chip/adapter (0 to quit)? prompt, enter the number
under Choice that corresponds to the SCSI chip associated with the
flash memory you want to update. Refer to the following example where
chip 1 is selected:
The following menu is displayed:
64
0x021 0x01 0x16
Which chip/adapter (0 to quit)? 1
Get other manuals https://www.bkmanuals.com
0x01 0x00 Am29F010
Chapter 2