HP A6829A User's Manual And Service Manual page 74

Installing the A6829A Adapter
Verifying Installation
•
•
•
•
•
Step 4. In addition, in the ioscan output, the ctl lines show the adapter's SCSI
ID in its hardware path (shown in bold in the example below, for
highlighting purposes):
ctl 0 0/0/10/0/0.7.0
ctl 1 0/0/10/0/1.7.0
Step 5. Verify that the devices you attached to the adapter are present in the
ioscan output. For example, a partial list may look like this:
disk 10 0/0/1/0/1.0.0
disk 11 0/0/1/0/1.2.0
disk 45 0/2/1/0/1.8.0
disk 46 0/2/1/0/1.10.0 sdisk
60
SCSI C1010—The type of HBA (SCSI) and the type of Ultra160
controller (C1010).
Ultra160—The HBA's maximum data transfer rate. This can be
Ultra160, Ultra2, Ultra, Fast, or Async. You should keep the
following in mind:
— This is not the actual transfer rate, but the maximum transfer
rate set for the HBA.
— This is either the firmware default or the rate set through the
BCH menus, unless you attach an SE device, which causes the
entire bus to change to a transfer rate of Ultra (see "Performance
Tuning" on page 13).
Wide—The HBA's bus width. This can be Wide or Narrow.
LVD—The HBA's bus type. This can be LVD or Single-Ended. If no
bus type is shown, then the SCSI channel is disabled.
A6829-60101—The HBA's HP part number.
sctl CLAIMED
/dev/rscsi/c0t7d0
sctl CLAIMED
/dev/rscsi/c1t7d0
sdisk CLAIMED
/dev/dsk/c1t0d0
sdisk CLAIMED
/dev/dsk/c1t2d0
sdisk CLAIMED
/dev/dsk/c9t8d0
CLAIMED
/dev/dsk/c9t10d0 /dev/rdsk/c9t10d0
Get other manuals https://www.bkmanuals.com
DEVICE Initiator
DEVICE Initiator
DEVICE SEAGATE ST39103LC
/dev/rdsk/c1t0d0
DEVICE SEAGATE ST39103LC
/dev/rdsk/c1t2d0
DEVICE HP 18.2GST318404LC
/dev/rdsk/c9t8d0
DEVICE HP 18.2GST318404LC
Chapter 2