Table of Contents
Advertisement
Cause
More than one person is connected to the
module console from Onboard Administrator.
The download fails after starting to download the
firmware file
Cause
The firmware file is not the correct file or is
corrupt.
The pass-thru module configuration is corrupt
Cause
An error was made when saving the pass-
thru module configuration.
SFP+ transceiver port is disabled
Cause
The SFP+ transceiver is not compatible with
the pass-thru module.
Action
Use the Onboard Administrator CLI show interconnect
sessions command to check for active sessions. If an
interconnect session is active, use the clear
interconnect session command to terminate active
sessions on the module.
Action
Obtain the latest firmware file that is specified for this pass-thru
module. See "Downloading a remote firmware image upgrade"
or "Downloading a serial firmware image upgrade" for more
information.
Action
1
Reboot the pass-thru module and reload the factory
settings. This action clears all settings and restores them to
the initial values that were present when the pass-thru
module was purchased.
2
After reloading the factory settings, reconfigure the pass-
thru module settings.
Action
Verify the SFP+ transceiver was purchased from HP. To
purchase an SFP+ transceiver from HP, contact an authorized
HP reseller.
Get other manuals https://www.bkmanuals.com
Troubleshooting 23
Advertisement
Table of Contents
