Makita 3606 Instruction Manual page 6

1
3
► 1. Straight guide 2. Guide bar 3. Wing bolt
When cutting, move the tool with the straight guide flush
with the side of the workpiece.
Templet guide (optional accessory)
The templet guide provides a sleeve through which
the bit passes, allowing use of the tool with templet
patterns.
To install the templet guide, loosen the screws on the
tool base, insert the templet guide and then tighten the
screws.
1
3
► 1. Base plate 2. Templet guide 3. Screw
Secure the templet to the workpiece. Place the tool on
the templet and move the tool with the templet guide
sliding along the side of the templet.
2
2
3
4
► 1. Bit 2. Base 3. Templet 4. Workpiece 5. Distance
(X) 6. Outside diameter of the templet guide
7. Templet guide
NOTE:
• The workpiece will be cut a slightly different
size from the templet. Allow for the distance (X)
between the bit and the outside of the templet
guide. The distance (X) can be calculated by
using the following equation:
Distance (X) = (outside diameter of the templet guide
- bit diameter) / 2
Trimmer guide (optional accessory)
2
Trimming, curved cuts in veneers for furniture and the
like can be done easily with the trimmer guide. The
guide roller rides the curve and assures a fine cut.
Install the trimmer guide on the tool base with the wing
bolt (B). Loosen the wing bolt (A) and adjust the dis-
tance between the bit and the trimmer guide by turning
the fine adjusting screw (1.5 mm or 1/16" per turn). At
the desired distance, tighten the wing bolt (A) to secure
the trimmer guide in place. When adjusting the guide
roller up or down, loosen the wing nut (C). After adjust-
ing it, tighten the wing nut (C) securely.
6 ENGLISH
1
7
5
6