Toro Groundsmaster 7200 Series Operator's Manual page 23

– Disengage the power takeoff and lower the
attachments.
– Engage the parking brake.
– Shut off the engine and remove the key.
– Wait for all moving parts to stop.
•
Do not operate the machine when there is the risk
of lightning.
•
Do not use the machine as a towing vehicle.
•
Use accessories, attachments, and replacement
parts approved by The Toro® Company only.
Rollover Protection System
(ROPS) Safety
•
Do not remove the ROPS from the machine.
•
Ensure that the seat belt is attached and that you
can release it quickly in an emergency.
•
Check carefully for overhead obstructions and do
not contact them.
•
Keep the ROPS in safe operating condition by
thoroughly inspecting it periodically for damage
and keeping all the mounting fasteners tight.
•
Replace damaged ROPS components. Do not
repair or alter them.
Machines with a Foldable Roll Bar
•
Always use the seat belt with the roll bar in the
raised position.
•
The ROPS is an integral safety device. Keep a
folding roll bar in the raised and locked position,
and use the seat belt when operating the machine
with the roll bar in the raised position.
•
Lower a folding roll bar temporarily only when
necessary. Do not wear the seat belt when the
roll bar is folded down.
•
Be aware that there is no rollover protection when
a folded roll bar is in the down position.
•
Check the area that you will be mowing and never
fold down a folding roll bar in areas where there
are slopes, drop-offs, or water.
Slope Safety
Slopes are a major factor related to loss of control and
rollover accidents, which can result in severe injury or
death. You are responsible for safe slope operation.
Operating the machine on any slope requires extra
caution.
•
Evaluate the site conditions to determine if the
slope is safe for machine operation including
surveying the site. Always use common sense
and good judgment when performing this survey.
•
Review the slope instructions listed below for
operating the machine on slopes and review
the conditions in which you would operate the
machine to determine whether you can operate
it in the conditions on that day and at that site.
Changes in the terrain can result in a change in
slope operation for the machine.
•
Avoid starting, stopping, or turning the machine on
slopes. Avoid making sudden changes in speed or
direction. Make turns slowly and gradually.
•
Do not operate a machine under any conditions
where traction, steering, or stability is in question.
•
Remove or mark obstructions such as ditches,
holes, ruts, bumps, rocks, or other hidden hazards.
Tall grass can hide obstructions. Uneven terrain
could overturn the machine.
•
Be aware that operating the machine on wet
grass, across slopes, or downhill may cause the
machine to lose traction. Loss of traction to the
drive wheels may result in sliding and a loss of
braking and steering.
•
Use extreme caution when operating the machine
near drop-offs, ditches, embankments, water
hazards, or other hazards. The machine could
suddenly roll over if a wheel goes over the edge
or the edge caves in. Establish a safety area
between the machine and any hazard.
•
Identify hazards at the base of the slope.
If there are hazards, mow the slope with a
pedestrian-controlled machine.
•
If possible, keep the cutting unit(s) lowered to the
ground while operating on slopes. Raising the
cutting unit(s) while operating on slopes can cause
the machine to become unstable.
•
Use extreme caution while operating the
machine with grass-collection systems or other
attachments. These can change the stability of the
machine and cause a loss of control.
23