Victron energy SmartSolar SCC900650010 Manual page 13

Nu
mb Scrolling text
er
57 RX MODE
58 TX MODE
SOFTWARE
61
VERSION
RESTORE
62
DEFAULTS
63 CLEAR HISTORY
64 LOCK SETUP
TEMPERATURE
67
UNIT
Page 11
SmartSolar Control display manual
LCD
Sets the VE.Direct port RX pin mode:
• 0 - The VE.Direct port is used for on/off control by an external
device, such as a BMS. It is an option to connect a BMS to the
VE.Direct port, (instead of connecting the BMS to the remote
on/off terminal). A
needed.
• 1 - No function.
• 2 or 3 - The RX pin is used to de-energize the relay.
An AND function can be created if the relay function (setting 10)
has been set to value 10 and the load control options (setting
35) remain valid. Both the load control and the RX pin must be
high (value 2) or low (value 3) to energize the relay.
Sets the VE.Direct port TX pin mode:
• 0 - Normal VE.Direct communication(default). For example
to communicate with a Color Control panel (VE.Direct cable
needed)
• 1 - Pulse every 0.01kWh
• 2 - Light dimming control (pwm normal). A
output cable
• 3 - Light dimming control (pwm inverted) A
output cable
• 4 - Load control mode: the TX pin switches according to the
load control mode (setting 35), see note. A
output cable
port.
Displays the firmware version of the solar charger.
Resets all settings to default.
Press SELECT: the text "RESET" will blink, press SELECT again
to reset to original factory settings. The charger will re-boot. The
history data will not be affected.
Resets all historic data.
Press SELECT: the text "CLEAR" will blink, press SELECT again
to erase the history data. Note that this takes a few seconds to
complete.
Locks settings (Y or N).
Sets the temperature unit to °C or °F (CELC or FAHR)
Desription and notes
VE.Direct non-inverting remote on/off cable
VE.Direct TX digital
is needed
VE.Direct TX digital
is needed.
VE.Direct TX digital
is needed to interface to a logic level load control
is
Operation