Biostar 945G Micro 775 TE Setup Manual page 76

945G Micro 775 TE / 945GC Micro 775
Onboard Parallel Port
This item allows you to determine access onboard parallel port controller with which
I/O Address.
The Choices: 378/IRQ 7 (default), 278/IRQ5, 3BC/IRQ7, Disabled.
Parallel Port Mode
The default value is SPP .
The Choices:
SPP (de fault) Using P arallel port as Standard P rinter Port.
EPP Using P arallel P ort as Enhanced P arallel Port.
ECP Using P arallel port as Extended Capabilities P ort.
ECP +EPP Using P arallel port as ECP & EPP mode.
ECP Mode Use DMA
Select a DMA Channel for the port.
The Choices: 3 (default), 1.
PWRON After PWR-Fail
This setting specifies whether your system will reboot after a power
fail or interrupts occurs.
Off Leaves the computer in the power off state.
On Reboots the computer.
Former-Sts Restores the system to the status before power failure or
interrupt occurs.
The Choices: Off (default), On, Former-Sts.
22