Biostar 945G Micro 775 TE Setup Manual page 73

945G Micro 775 TE / 945GC Micro 775
IDE HDD Block Mode
Block mode is also called block transfer, multiple commands, or multiple sector
read / write. If your IDE hard drive supports block mode (most new drives do),
select Enabled for automatic detection of the optimal number of block mode
(most new drives do), select Enabled for automatic detection of the optimal
number of block read / write per sector where the drive can support.
The Choices: Enabled (default), Disabled.
IDE DMA Transfer Access
This item allows you to enable or disable the IDE transfer access.
The Choices: Enabled (default), Disabled.
On-chip Primary/Secondary PCI IDE
This item allows you to enable or disable the primary/ secondary IDE Channel.
The Choices: Enabled (default), Disabled.
IDE Primary/Secondary Master/Slave PIO
The IDE P IO (P rogrammed Input / Output) fields let you set a P IO mode (0-4) for
each of the IDE devices that the onboard IDE interface supports. Modes 0 to 4 will
increase performance progressively. In Auto mode, the system automatically
determines the best mode for each device.
The Choices: Auto (default), Mode0, Mode1, Mode2, Mode3, and Mode4.
IDE Primary/Secondary Master/Slave UDMA
Ultra DMA/100 functionality can be implemented if it is supported by the IDE hard
drives in your system. As well, your operating environment requires a DMA driver
(Windows 95 OSR2 or a third party IDE bus master driver). If your hard drive and
your system software both support Ultra DMA/100, select Auto to enable BIOS
support.
The Choices: Auto (default), Disabled.
SATA Mode
The Choices: IDE (default), RAID, AHCI.
On-Chip Serial ATA
This item allows you to choose:
Disabled: disabled SATA Controller
Combined Mode: PATA and SATA are combined max of 2 IDE drivers
in each channel.
Enhanced Mode: enabled both SATA and PATA max o f 6 IDE drivers
are supported.
SATA Only: SATA is operating in legacy mode.
The Choices: Disabled, Auto, Combined Mode, Enhanced Mode (default),
and SATA only.
19