Table of Contents
Advertisement
Flush installation
Installation
Fitted units
This appliance is only intended to be fully fitted in a kitchen.
This appliance is not designed to be used as a tabletop
appliance or inside a cupboard.
The fitted cabinet must not have a back wall behind the
appliance.
A gap of at least 45 mm must be maintained between the
wall and the base or back panel of the unit above.
The fitted cabinet must have a ventilation opening of 250 cm
on the front. To achieve this, cut back the base panel or fit a
Installation dimensions
Note: There should be a gap above the oven.
Flush installation also requires:
2
min 45
min 45
4 88
Ventilation grid
Cupboard feet
8
two side cleats to be attached inside the cabinet
frame, recessed from the front
a
/
" (8 mm) baseplate underneath the unit body.
5
16
ventilation grille.
Ventilation slots and intakes must not be covered.
The safe operation of this appliance can only be guarantee
if it has been installed in accordance with these installation
instructions.
The fitter is liable for any damage resulting from incorrect
installation.
The units into which the appliance is fitted must be heat-
resistant up 90 C.
o
50
488
250
724
Advertisement
Table of Contents
