For Line Trimmer Use - Craftsman BRUSHWACKER 358.798260-32cc Operator's Manual

I I I I il lllIl I IIIIII
B.FOR LINE TRIMMER USE _ ,,:
: A WARNING
fiastic shield must be ' installed for
trimmer shield pro-
risk of thrown
ecte to operator and others and is
with a line limiter which cuts excess
the proper length.
AWARNI_G : ._.:
Failure to install shield in the position shown
can result in serious injury to the oper*
ator. The length of the shield must be aligned
with the length of the drive shaft housing. Di-
rect the widest part of shield toward the engine.
NOTE." Remove the metal shield and blade before
• installing the plastic shield and trimmer head.
1. Place the shield under the bearing housing and
_.align screw holes. .......... _=
The line limiter (on the underside of
the shield) is sharp and can cut you,
2. Insert screws "D." through the bearing housing
into the shield.
31 Tighten the screws evenly and securely.
4. Remove the packing cover from the arbor shai_ if so
equipped.
5. Install grass washer "K? over the arbor shaft Make
sure the grass washer is against and curved over the
dust cup.
6. Start thread_g tl_e trimmer head onto the arbor
shaft.
7. Align the hole in the dust cUp with the hole m the
center front of the bearing housing by turning me
dust cup. Then, insert the small hex wrench (pro-
vided) into the aligned holes to keep the arbor shat_
from turning.
8. Tighten thetrimmer head againstthewasher and
dustcup whileholdingthehex wrench.
9. RemOve the hex wrench.
To remove the trimmer head, insert the
hex wrench into the aligned holes in the dust cup
and bearing housing. Unthread the trimmer head.
Be sure to store grass washer"K?, plastic shield, 4
shield screws, and hardware with the trimmer head
for future use.
Bearing
Housing
Clamp
Hex
Screw D.
Dust Cup
!
Widest Part Line
of Shield
Toward
Engine
Direction
to Install
Arbor Shaft
Grass
Washer K.
Trimmer
8