Callaway CSI Pro - Laser Rangefinder Manual

CSi CLUB SUGGESTION SET-UP

To set up CSi, you Will first need to know your 7-iron distance in your preferred unit of measure (yards/ meters). Based on that information, the proprietary firmware will then make club suggestions based on the distance you measure.

1. To set your 7-iron distance, start with the CSi laser in the OFF position. HOLD the POWER button for 10 seconds to engage CSi set up mode
   In the initial "SET" interface screen,
   
2. While in the "SET" interface, HOLD the POWER button for an additional 3 seconds to toggle to the club distance setting. Tapping the POWER button will add (+) 1 yard/meter, tapping the MODE button will (-) 1 yard/meter.
   
3. Once correct distance is set, HOLD the POWER button for 3 seconds to confirm. Once you see both icons flashing, tap the POWER button again to engage the "OUT" screen, then hold the POWER button an additional 3 seconds to return to the main screen.
   To tum the CSi club suggestion ONIOFF, simply HOLD the Mode
   Button for 3 seconds while on the main screen

RANGEFINDER DIAGRAM

1. Eye Piece
2. Diopter Adjustment
3. Power Button
4. Mode Button
5. Slope Switch
6. Battery Door

LCD DISPLAY

1. Zero-In Aiming Circle
2. Laser Indicator Box
3. PA.T. Mode Indicator
4. Pulse Indicator
5. Distance
6. Unit of Measure
7. Angle of Incline/Decline
8. .Slope Adjusted Distance
9. Battery Indicator
10. Club Suggestion

HOW TO USE

1. While looking through the Eye Piece, PRESS & RELEASE the Power Button. The rangefinder is now powered on
   
2. To focus/increase clarity, use the Diopter Adjustment by turning the Eye Piece.
   
3. Continue looking through the Eye Piece, aim the Zero-In Aiming Square at your intended target & PRESS the Power Button. The laser will fire and the Laser Indicator will appear to the left of the Zero-In Aiming Square. The measurement wil be displayed at the top of the LCD display.
   

MEASUREMENT MODES

1. Standard- Standard mode is recommended when measuring distances to larger objects. (Fig. A)
   
2. P.A.T with Pulse Technology- PAT. mode is best used when measuring the distance to a flagstick or smaller objects. Device will provide a short vibration to confirm that the laser has locked onto the pin. To toggle between Standard and mode, PRESS the Mode once while the device is powered on. When mode is activated, the flagstick icon will appear at the top of the LCD display (Fig. B). To turn pulse ON/OFF, quickly PRESS the Mode Buton Twice.
   
   NOTE: While scanning in PAT. 'node, Hie measurement will ony change when a shorter distance is measured. This is useful when measuring the to a flagstick when there are trees or other objects in Hie bækground_
3. Scanning - To measure distances to multiple targets in succession, PRESS and RELEASE Power Button to power on. Then HOLD the Power Button, the Laser Indicator Box will flash and the laser will continuously fire. Measurements will change as you scan the landscape and change targets.
4. Unit of Measure- To change the unit of measure from yards to meters, start with the device powered on. Then HOLD the Mode Button for 10 sec. The unit of measure is indicated by a 'Y' or 'M' shown directly to the right of the distance displayed.

SLOPE FUNCTION

The Slope Switch on the side of the CSi PRO has two positions:

1. RED is showing: Slope function is off. The laser is tournament legal when the slope is tumed off.
   
2. GREEN is showing: Slope function is enabled. Slope adjusted yardage will be displayed after every time the laser is fired. The laser is not tournament legal when the slope is enabled.
   

Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure.