Replace battery cap & tighten by turning clockwise.
NOTE: When the Battery Indicator icon is empty, there are approximately 200 ranges left until the battery is completely drained. The Battery Indicator icon will flash when the battery needs to be replaced.
RANGEFINDER DIAGRAM
Eye Piece
Diopter Adjustment
Power Button
Mode Button
Slope Switch
Battery Door
LCD DISPLAY
Zero-In Aiming Circle
Laser Indicator Box
P.A.T. Mode Indicator
Pulse Indicator
Distance
Unit of Measure
Angle of Incline/Decline
Slope Adjusted Distance
Battery Indicator
HOW TO USE
While looking through the EyePiece, PRESS and RELEASE the Power Button. The rangefinder is now powered on.
To focus/increase clarity, use the Diopter Adjustment by turning the Eye Piece.
Continue looking through the EyePiece, aim the Zero-In Aiming Circle at your intended target and PRESS the Power Button. The laser will fire and the Laser IndicatorBox will appear around the Zero-In Aiming Circle. The measurement will be displayed at the top of the LCD display.
MEASUREMENT MODES
Standard - Standard Mode is recommended when measuring distances to larger objects. (Fig. A)
P.A.T. with Pulse Technology - P.A.T. Mode is best used when measuring the distance to a Flagstick or smaller objects. Device will provide a short vibration to confirm that the laser has locked on to the pin. To toggle between Standard and P.A.T Mode, quickly PRESS the Mode Button once while device is powered on. When P.A.T. Mode is activated, the flagstick icon will appear on the left side & the Pulse icon will appear at the top of the LCD display (Fig. B). To turn Pulse ON/OFF, quickly PRESS the Mode ButtonTwice.
Scanning - To measure distances to multiple targets in succession, PRESS & RELEASE the Power Buttonto power on. Then HOLDPower Button, the Laser Indicator Box will flash and the laser will continuously fire. Measurements will change as you scan the landscape and change targets. NOTE: While scanning in P.A.T. Mode, the measurement will only change when a shorter distance is measured. This is useful when measuring the distance to a flagstick when there are trees or other objects in the background.
Unit of Measure - To change the unit of measure from Yards to Meters, start with the device powered off. Then HOLD the Mode Button for 3 sec. The unit of measure is indicated by a "Y" or "M" shown directly to the right of the distance displayed.
SLOPE FUNCTION
Device will measure the angle of incline/decline in the bottom right of the display (A), then calculate & display the slope adjusted distance in the bottom left of the display (B).
The Slope switch on the Side of the 300PROhas two positions:
REDis showing: Slope function is off. The Laser is tournament legal when the slope is turned off.
GREENis showing: Slope function is enabled. Slope adjusted yardage will be displayed after every time the laser is fired. The Laser is not tournament legal when the slope is enabled.
OPERATIONAL NOTES
The maximum measurement range is 5-1000 yards to objects and 5-300 yards to a flagstick with +/- 1 yard accuracy. NOTE: Maximum range can depend on several factors, including target characteristics and environmental conditions. For instance, longer maximum distances may be obtained to targets that are large in size, brightly colored, or have a reflective finish. Ranging capability can also be affected by the angle to the target and lighting conditions.
Auto Shutoff - To conserve battery life, the device will automatically power off when idle for more than 10 seconds.
Weather Conditions - Heavy rain and thick fog can potentially limit the maximum range of the device.
Weather Resistant - Protected against light rain.
STORING THE LASER
Do not leave the eyepiece in direct sunlight. The condenser effect of the lens may damage the internal display surface.
MAINTENANCE
To clean, use only a soft, clean cloth to prevent scratches.
Do not submerge in liquid or apply any cleaning products.
Do not store in extremely hot/cold temperatures (<50°F - >110°F).
Store in carrying case when not in use.
TROUBLESHOOTING
Rangefinder is consistently providing inaccurate measurements
Make sure the device is set to the desired unit of measure (Yards or Meters).
Weak battery signal can affect the accuracy of the device. If the Battery Indicator is flashing on the LCD display, replace the battery.
Make sure there isn't anything obstructing your view such as leaves, branches, your finger, etc.
When looking through the Eye Piece, the view is blurry
Use the Diopter Adjustment by turning the Eye Piece to focus/ increase clarity.
Make sure there isn't anything obstructing your view such as leaves, branches, your finger, etc.
Use a soft, clean cloth to clean lens.
When should the battery be replaced?
If the Battery Indicator is flashing on the LCD display.
If the rangefinder is consistently providing inaccurate measurements.
If the LCD display is not present when PRESSING the Power Button.
What type of battery does the rangefinder use?
CR2 3-Volt Lithium Battery.
When should P.A.T. Mode be used?
When measuring the distance to smaller targets such as a flagstick.
When scanning the landscape to measure distances to a smaller target such as a flagstick and there are trees or other objects in the background.
If you have any other questions or concerns, please call 800-456-2129 or go to www.callawaytag.com.
WARRANTY POLICY
This product is warranted to be free from defects for up to (1) year from the original purchase date. IZZO Golf cannot refund your purchase unless purchased directly from IZZO Golf. IZZO Golf will replace or repair any unit that is determined defective under normal use within the warranty period. Please call Customer Service at 800-456-2129 to request a Return Authorization. All defective products must be returned to:
Please include a note with your Name, Address, Phone # and the Return Authorization #.Your replacement will be shipped once we diagnose the returned unit.
WARNING
NEVERlook directly into the sun or intense light when using the laser rangefinder.
DO NOTaim/point laser rangefinder at another person.
DO NOTaim/point laser rangefinder at anyone's eyes or face.
DO NOTattempt to disassemble the laser rangefinder.
DO NOTsubmerge in any liquid.
DO NOTstore the laser rangefinder in extreme cold/hot temperatures (<50°F - >110°F).
Need Assistance?
Do you have a question about the 300 PRO that isn't answered in the manual? Leave your question here.