Table of Contents
Advertisement
Maintaining your appliance
CAUTION
After replacing the door, make sure to reconnect the wires. Push them inward
to arrange them as they were before you removed the door. Wires that are not
connected or arranged correctly can be caught in the door or damaged by heat.
70 English
4.
Lower the oven door to the fully open
position. If the oven door does not open
to a full 90 °, repeat steps 1 through 3.
5.
Locate the oven door hinge locks in
the corners of the oven door, and
rotate the hinge locks toward the oven
cavity to the locked position. See Step
3 (illustration A) in the Removing the
oven doors section for the proper
locked position.
6.
Close the oven door.
7.
When the hinges are properly installed
and the door is closed, there should be
an even gap between the door and the
control panel. If one side of the oven
door is hanging lower than the other,
the hinge on that side is not properly
installed.
Changing the oven light (Lower oven only)
The oven light is a standard 40-watt appliance halogen bulb. It comes on when the
oven door is open. When the oven door is closed, touch Light to turn the light on
or off. It will not work during a self-cleaning cycle.
CAUTION
Before changing the oven light, make sure to wear gloves to protect your hands.
01
1.
To change the halogen bulb, you must
tilt the broil heater down. To do this,
turn the circular nut on the support
counterclockwise while holding the
broil heater. The broil heater should
loosen and tilt down.
CAUTION
The broil heater is not a removable part. Do
not force the broil heater down. Do not let it
drop down.
2.
While holding the glass cover with one
hand, insert a flat-sharp tool such as a
table knife between the glass and the
frame to remove the glass cover.
Advertisement
Table of Contents
