Table of Contents
Advertisement
Burr Zero Point
The point where the burrs can no longer be adjusted finer. When turning the adjustment
dial finer, it will encounter total resistance and will not be able to turn.
DO NOT attempt to turn on the grinder when burrs are at zero as damage may occur.
Note that the "0" on the grind adjustment ring does not equal the Burr Zero Point for your
Orbit.
Burr Touch Point
The point where the burrs make initial contact with each other, and make an audible
sound of metal-on-metal scraping. This is the finest possible grind setting. If performing
a burr alignment or installing new burrs, the burr touch point may change position. Orbit
users are advised that attempting to grind finer than the burr touch point may result in
damage to the burrs or motor.
Stepless Adjustment
Orbit's setting dial has a 0.75 mm thread pitch that allows smooth and continuous
adjustment from espresso to filter coffee in just one rotation. That gives plenty of room
to fine-tune your shots, as well as swap from small pour over brews to large batches
whenever you need to.
Auto-stop
The Orbit will automatically stop grinding once the bean chamber is empty after 3
seconds. If the Orbit is turned on without any beans in it, the grinder will automatically stop
after 15 seconds.
You can adjust the auto-stop setting through the Orbit App for continuous grinding. Once
the auto-stop setting is turned off, the grinder will continue grinding until it is manually
stopped by the Orbit button.
10
Advertisement
Table of Contents
