Table of Contents
Advertisement
PROGRAMMING - H5 ELEMENT
Adjusting temperature:
The switch must be in the "SET" position in order to
access the program modes.
1. Press and hold "TEMP" button until display
flashes.
2. While display is flashing, press and release the
(+) to increase or (-) to decrease temperature.
NOTE: (Starting with software version 0.07)
If unit is "E" model, temp will stop at 211°F (99°C).
If unit is "X" model, temp display will jump from
211°F (96°C) to 212°F (100°C).
Refer to chart on page 3 and adjust temperature
requirements according to altitude.
Program lockout switch:
The switch must be in the "SET" position in order to
access the program modes.
1. Disconnect the dispenser from the power source.
2. Remove the 4-40 screws and the top cover.
3. Use a small screwdriver to move switch to set
position.
4. Install top cover, connect dispenser to power
source.
®
Manual Energy Saver Mode:
The energy save mode will allow the tank temperature
1. Simultaneously press and release the (+) and (-)
2. The display will alternately flash between 140
3. Repeat procedure to exit energy save mode.
Step forward
Step backward
Programming the dispenser:
1. Press and hold upper hidden button (bottom
Continued
12
to drop down to 140°F (60°C).
to "manually" activate energy save mode.
and the current temperature to indicate it is in
the energy save mode.
READY
TEMP
ENERGY SAVER MODE
WARNING
HOT WATER
HOT WATER
center of "BUNN" logo) until "P1" is displayed.
Advertisement
Table of Contents
