Section 1
POWER Keys
To turn
keys.
CO
2
portion is going to be used, the unused half can be disabled to avoid nuisance alerts and error
messages. With the monitor turned on, press either POWER key to shut down that half of the monitor.
Press the key again turn that half back on. To turn CO
the power key associated with the active parameter.
AC Mains Operation
CO
SMO
2
AC Mains power is removed or not present. An illuminated AC ON
connected to AC Mains power and the internal battery is being charged.
To power
connector. Set the rear panel power switch to the "|" (ON) position. Plug the other end of the line cord to
a properly grounded three-wire outlet.
Caution: Ensure the
otherwise power for the monitor is drawn from the internal battery. This can result in the monitor shutting
itself off if the battery is allowed to drop to the low battery state. See "Battery Operation" on page 6.
Battery Operation
CO
SMO
2
"O" (OFF) position.
While on battery power,
indicates a fully charged battery,
6
SMO User's Manual
CO
2
on, press either the
CO
SMO
2
SMO powers up as a combined ETCO
Press
key
to turn off CO
2
Press
key
to turn off SpO
2
uses AC Mains (line cord) power if available and automatically switches to battery operation if
from AC Mains (line cord) power; Plug the line cord into the rear panel AC input
CO
SMO
2
AC ON
uses battery power if the line cord is disconnected or the rear panel power switch is set to the
can operate up to two hours from its internal battery.
CO
SMO
2
CO
SMO
2
or
key. To turn the monitor off, press both the
NOTE
/SpO
monitor. If only the capnograph or pulse oximeter
2
2
SMO off while only one parameter is active, press
2
NOTE
indicator is illuminated when operation from AC mains is desired,
displays a battery icon to the right of the numerical Respiration display.
a half charge, and
Front Panel Controls and Connectors
indicator means the
indicates less than 30 minutes of battery
and
is
CO
SMO
2
Rev. 04
Need help?
Do you have a question about the CO2SMO and is the answer not in the manual?