Saeco SM8782/30 User Manual page 21

Problem
I cannot remove the brew
group.
I cannot insert the brew
group.
The coffee is watery.
The coffee is not hot
enough.
Coffee does not come out
or coffee comes out
slowly.
Cause
The brew group is not in the
correct position.
The brew group is not in the
correct position.
The brew group is dirty or needs
to be lubricated.
The machine is performing its self-
adjustment procedure. This
procedure is started automatically
when you use the machine for the
first time, when you change to
another type of coffee beans or
after a long period of non-use.
The grinder is set to a too coarse
setting.
The temperature is set too low.
A cold cup reduces the
temperature of the drink.
Adding milk reduces the
temperature of the drink.
The AquaClean water filter was
not prepared properly for
installation.
Solution
Reset the machine in the following way:
close the service door. Switch the machine
off and back on again and wait until the
machine is ready for use. Try to remove
the brew group again. See chapter
'Removing and inserting the brew group'
for step-by-step instructions.
Reset the machine in the following way:
close the service door. Leave the brew
group out. Switch off the machine and
unplug it. Wait for 30 seconds and then
plug the machine back in, switch it on and
wait until the machine is ready for use.
Then put the brew group in the correct
position and reinsert it into the machine.
See chapter 'Removing and inserting the
brew group' for step- by-step instructions.
Remove the brew group, rinse it under the
tap and leave it to dry. Then lubricate the
moving parts (see 'Lubricating the brew
group').
Brew 5 cups of coffee initially to allow the
machine to complete its self-adjustment
procedure.
Set the grinder to a finer (lower) setting.
Brew 2 to 3 drinks to be able to taste the
full difference.
Set the temperature to the maximum
setting (Fig. 42).
Preheat the cups by rinsing them with hot
water.
Regardless of whether you add hot or cold
milk, adding milk always reduces the
temperature of the coffee. Preheat the
cups by rinsing them with hot water.
Remove the AquaClean filter and dispense
some hot water. If this works, the
AquaClean filter was not installed
properly. Reinstall and activate the
AquaClean filter and follow all steps in
chapter 'AquaClean water filter'.
19
English