Operation - Hyundai HASBT35 Instructions Manual

Danger of fire and burn injuries
 Always use extreme care when handling fuel! Fuel is highly flammable.
 Never attempt to fuel the vacuum blower if the fuel system components are damaged or are
leaking.
 Never attempt the refuel the engine while it is running or still warm, allow it to cool before
fuelling.
 Never smoke or light any fires near the vacuum blower or fuels.
 Always transport and store fuels in an approved container.
 Never place flammable material closes the engine muffler.
 Never operate the vacuum blower without a properly functioning muffler and spark arrestor
installed.
 Never operate the vacuum blower unless it is properly assembled and in good working
condition.
 Do not use petrol which contains ethanol or methanol as it may damage the fuel lines and
other engine parts.
 Mix only enough fuel for your immediate needs. If fuel must be stored longer than 30 days, it
should first be treated with a stabilizer or similar product.

5. OPERATION

a. Before starting
- Be sure that you have correctly completed the installation.
- Inspect the work area. Make sure there are no obstacles or dangerous debris that could
damage the tool.
b. Start/stop the machine
NOTE: Starting the product differs depending on whether the engine is cold or warm.
1. Move the ignition switch to the on position marked I.
2. Move the choke lever upwards to the start position (cold start).
Note. This is not required if the engine is already warm.
3. Push the primer button 8 times, until the petrol/oil mixture flows in and out of the discharge
hose located above the fuel tank.
4. Pull the recoil starter 2-3 times until you hear the engine starting.
5. Push the choke lever down to the run position (warm start).
11