PCB Piezotronics IMI SENSORS 686C01 Installation And Operating Manual page 29

Usb-programmable electronic vibration switch, relay output, 0.25 to 5 in/sec pk, 2 to 1k hz, top exit, 2-pin conn

Hide thumbs Also See for IMI SENSORS 686C01:

Table of Contents

After the software completes, the USB driver installer will start automatically. The initial USB installer will look

similar to the one below.

Figure 30 – WinUSB Driver Installation Screen

The drivers will now be properly installed and you should get the following screen. Click "Finish". The software is

now ready to use.

Figure 31 – WinUSB Driver Installation Complete Screen

PAGE 24

Table of Contents

Need help?

Do you have a question about the IMI SENSORS 686C01 and is the answer not in the manual?