PCB Piezotronics IMI SENSORS 686C01 Installation And Operating Manual page 18

Usb-programmable electronic vibration switch, relay output, 0.25 to 5 in/sec pk, 2 to 1k hz, top exit, 2-pin conn

Hide thumbs Also See for IMI SENSORS 686C01:

Table of Contents

Using Two Switches in Parallel to Monitor Two Axes Simultaneously on Same Motor

Figures 13 and 14 – Using Two Switches in Parallel to Monitor Two Axes Simultaneously on Same Motor

The Smart Switches are hooked up in parallel and installed on the motor in horizontal and vertical directions.

Pushing the Start pushbutton closes the M contact and starts the motor. If the start-up delay option for the

switches is enabled, then during the specified startup delay time, the switches will not trip regardless of the

vibration level. After this delay, the alarm siren will be activated if either of the switches experiences a vibration

level over the alarm threshold lasting greater than the specified operation delay time.

PAGE 13

Table of Contents

Need help?

Do you have a question about the IMI SENSORS 686C01 and is the answer not in the manual?