Detecting And Setting Up The Initial Ip Address - Sony EBS-N200 User Manual

Detecting and Setting Up the Initial IP Address

Once power has been applied to the unit, an IP address must be
assigned either automatically thru DHCP or manually thru the
EBS-N200's web interface. Diskless and hard drive equipped
EBS-N200s are pre-configured differently as follows:
Diskless EBS-N200 IP Address Configuration:
All diskless EBS-N200's are shipped with the DHCP enabled and
rely on the boot server to supply an IP address. Diskless systems
are also set up to work with a Domain Name Server (DNS)
allowing an actual text string to be used as opposed to the units IP
address when accessing the unit thru a browser. The default
name of "EBS-N200" can be used for initial access to the unit thru
a browser and should be changed during configuration since
additional un-configured EBS-N200s on the network will have the
same name. Because of this only one EBS-N200 should be
powered up and configured at a time to prevent network conflicts.
Refer to the EBS-N200 Sever Software Users Guide for Server,
DHCP, and DNS set up.
Hard Drive Equipped EBS-N200 IP Address Configuration:
All EBS-N200's equipped with a hard drive are shipped with a
Static IP Address of 192.168.0.10. This IP address can be
changed as follow:
• Connect the EBS-N200 to a computer with the same sub-
net (192.168.0.XXX)
•
Start the computers browser and enter 192.168.0.10
•
The EBS-N200's main web page will appear; select the
Configure tab and the following page will appear
•
Set the desired IP address, Subnet Mask, and Default
Gateway and document
•
Select Submit and Restart to reboot the unit for the new
IP Address to take effect
EBS-N200 Network Display Adapter 8