System Setting; Event Log; Demo - Foster 7131 054 Instructions For Installation And Use Manual

10 - System Setting

EN
With the oven on, select the icon
key to enter the SETTINGS menu. This menu permits setting
a number of parameters or special functions. It also permits
accessing the error events list.
1. Press the keys to select the sub menu and confirm with
the key.
2. Use this menu to change the following settings:
Press the keys
displayed from among the three available ones and confirm
with the key.
EVENT LOGS
MAIN VOLTAGE

DEMO

Event Log

The menu permits checking any recorded errors. These codes
can be notified to the after-sales service.
01 12/11/2015 07:06 CODE: F10305
02 17/11/2015 13:17 CODE: F10305
14
and confirm with the
SETUP
SERVICE
to select the item to be set or to be
SYSTEM
OM 15
EVENT LOGS
Demo
The purpose of this function is to set the DEMO mode, which
makes the oven useless for cooking but automatically performs
a demonstration of functions.
1. Press the keys to select the item ON.
2. Confirm with the key.
3. Press the key.
After about 30 seconds, the oven starts to operate in this mode.
To temporarily stop the DEMO function, simply keep any key
pressed for a few seconds until the oven switches to standby.
To start it again, press the
To disable the function, enter the DEMO display page and set
OFF. Confirm using the key.
NOTE Once set, the function remains enabled even if the
oven is disconnected from the power mains.
DEMO
key.
ON