Getting Started - KitchenAid KHBRV00 Owner's Manual

LITHIUM-ION BATTERY OPERATED PRODUCT DISPOSAL
Always dispose the Battery operated products according to federal, state, and local
regulations. Contact a recycling agency in your area for recycling locations.

GETTING STARTED

BEFORE FIRST USE
1. Charge the Battery until it is fully charged.
2.
Clean all the parts and accessories (see "Care and Cleaning" section).
3.
Remove all packaging materials, if present.
NOTE: Some dust may be on the product. This is due to the recycled materials used in
packaging. This can be cleaned with a soft towel.
BATTERY CHARGING
USING THE USB CABLE
1.
Attach the USB cable to the adapter. Connect the other end of the USB cable to the
Battery.
2.
Plug the adapter into a power source.
USING THE DOCKING STATION (OPTIONAL)
1.
Attach the USB cord to the adapter.
2.
Plug the adapter into a power source.
3.
Turn the Battery upside down and slide the Battery onto the dock.
4.
Press down and the latch will snap into place.
5.
Upon initial plugging in the Battery into the charger, the Battery LEDs will alternate for a
few seconds as it performs a self-diagnostic of the Battery status.
6.
After diagnostic is complete, the Battery will begin charging with a single LED flashing.
LEDs will become solid in color as charging progresses. Battery is fully charged when all
LEDs are solid.
NOTE: If initial alternating light pattern continue for more than 10 seconds, the Battery may be
too warm or too cold to charge. Unplug Battery and allow it to stabilize to a normal room
temperature and try charging again. If Battery still not charge after this, unplug Battery and
contact customer service.
BATTERY STATUS
LED Indication
○○○○
○○○�
○○��
○���
⛭���
Battery Level
When Battery has only 10% Battery level, 1 LED
start to flash at rate of 1 second ON / 1 second OFF
(0.5 Hz).
75-100%
50-75%
25-50%
< 25%
5