Table of Contents
Advertisement
INSTALLATION
The stainless steel exterior of the cabinet has been protected by a plastic covering during manufacturing and shipping. This
covering can be readily stripped before installation. After removing this covering, wash the interior and exterior surfaces using a
warm, mild soapy water solution and a sponge or soft cloth. Rinse afterward with clean water and wipe dry. Do not use chlorinated
cleaners.
Location:
When locating your new Silver King unit, convenience and accessibility are important considerations, but the following installation
guidelines must be observed;
• Always avoid locating the unit adjacent to an oven, heating element or hot air source which could adversely affect the
performance of the unit.
• The unit must be level.
• For proper ventilation, the bottom front of the unit must not be obstructed.
Legs/Casters:
Models without a base come with Legs or Casters. To install them, tilt the unit and thread the Legs or Casters into the four Rivnuts
in the bottom of the cabinet. Make sure that they are installed tightly to prevent future thread wear.
Shelves:
Inside the unit you will find Shelves and a plastic bag containing Shelf Supports. This shelf system allows for easy adjustment to
suit your needs.
Door Adjustment and Swing:
Should the door ever require straightening, loosen the screws on the hinges, square the door with the cabinet and retighten the
screws.
The mounting of the door is easily reversible on single door units should space or convenience require that you do so. Simply remove
the screws holding the hinges, rotate the door 180 degrees and relocate the hinges on the side opposite their original location.
4
Advertisement
Table of Contents
